GK SDK 源码库: XMIPCLinuxV100R005C00SPC030 (kernel/tools/open_source excluded)

source/bootloader/u-boot-2020.01/board/theadorable/fpga.c

@@ -0,0 +1,178 @@
+// SPDX-License-Identifier: GPL-2.0+
+/*
+ * Copyright (C) 2016 Stefan Roese <sr@denx.de>
+ */
+
+#include <common.h>
+#include <altera.h>
+#include <errno.h>
+#include <asm/gpio.h>
+#include <asm/io.h>
+#include <asm/arch/cpu.h>
+#include <asm/arch/soc.h>
+#include <asm/arch-mvebu/spi.h>
+#include "theadorable.h"
+
+/*
+ * FPGA programming support
+ */
+static int fpga_pre_fn(int cookie)
+{
+	int gpio_config = COOKIE2CONFIG(cookie);
+	int gpio_done = COOKIE2DONE(cookie);
+	int ret;
+
+	debug("%s (%d): cookie=%08x gpio_config=%d gpio_done=%d\n",
+	      __func__, __LINE__, cookie, gpio_config, gpio_done);
+
+	/* Configure config pin */
+	/* Set to output */
+	ret = gpio_request(gpio_config, "CONFIG");
+	if (ret < 0)
+		return ret;
+	gpio_direction_output(gpio_config, 1);
+
+	/* Configure done pin */
+	/* Set to input */
+	ret = gpio_request(gpio_done, "DONE");
+	if (ret < 0)
+		return ret;
+
+	gpio_direction_input(gpio_done);
+
+	return 0;
+}
+
+static int fpga_config_fn(int assert, int flush, int cookie)
+{
+	int gpio_config = COOKIE2CONFIG(cookie);
+
+	debug("%s (%d): cookie=%08x gpio_config=%d\n",
+	      __func__, __LINE__, cookie, gpio_config);
+
+	if (assert)
+		gpio_set_value(gpio_config, 1);
+	else
+		gpio_set_value(gpio_config, 0);
+
+	return 0;
+}
+
+static int fpga_write_fn(const void *buf, size_t len, int flush, int cookie)
+{
+	int spi_bus = COOKIE2SPI_BUS(cookie);
+	int spi_dev = COOKIE2SPI_DEV(cookie);
+	struct kwspi_registers *reg;
+	u32 control_reg;
+	u32 config_reg;
+	void *dst;
+
+	/*
+	 * Write data to FPGA attached to SPI bus via SPI direct write.
+	 * This results in the fastest and easiest way to program the
+	 * bitstream into the FPGA.
+	 */
+	debug("%s (%d): cookie=%08x spi_bus=%d spi_dev=%d\n",
+	      __func__, __LINE__, cookie, spi_bus, spi_dev);
+
+	if (spi_bus == 0) {
+		reg = (struct kwspi_registers *)MVEBU_REGISTER(0x10600);
+		dst = (void *)SPI_BUS0_DEV1_BASE;
+	} else {
+		reg = (struct kwspi_registers *)MVEBU_REGISTER(0x10680);
+		dst = (void *)SPI_BUS1_DEV2_BASE;
+	}
+
+	/* Configure SPI controller for direct access mode */
+	control_reg = readl(&reg->ctrl);
+	config_reg = readl(&reg->cfg);
+	writel(0x00000214, &reg->cfg);		/* 27MHz clock */
+	writel(0x00000000, &reg->dw_cfg);	/* don't de-asset CS */
+	writel(KWSPI_CSN_ACT, &reg->ctrl);	/* activate CS */
+
+	/* Copy data to the SPI direct mapped window */
+	memcpy(dst, buf, len);
+
+	/* Restore original register values */
+	writel(control_reg, &reg->ctrl);
+	writel(config_reg, &reg->cfg);
+
+	return 0;
+}
+
+/* Returns the state of CONF_DONE Pin */
+static int fpga_done_fn(int cookie)
+{
+	int gpio_done = COOKIE2DONE(cookie);
+	unsigned long ts;
+
+	debug("%s (%d): cookie=%08x gpio_done=%d\n",
+	      __func__, __LINE__, cookie, gpio_done);
+
+	ts = get_timer(0);
+	do {
+		if (gpio_get_value(gpio_done))
+			return 0;
+	} while (get_timer(ts) < 1000);
+
+	/* timeout so return error */
+	return -ENODEV;
+}
+
+static altera_board_specific_func stratixv_fns = {
+	.pre = fpga_pre_fn,
+	.config = fpga_config_fn,
+	.write = fpga_write_fn,
+	.done = fpga_done_fn,
+};
+
+static Altera_desc altera_fpga[] = {
+	{
+		/* Family */
+		Altera_StratixV,
+		/* Interface type */
+		passive_serial,
+		/* No limitation as additional data will be ignored */
+		-1,
+		/* Device function table */
+		(void *)&stratixv_fns,
+		/* Base interface address specified in driver */
+		NULL,
+		/* Cookie implementation */
+		/*
+		 * In this 32bit word the following information is coded:
+		 * Bit 31 ... Bit 0
+		 * SPI-Bus | SPI-Dev | Config-Pin | Done-Pin
+		 */
+		FPGA_COOKIE(0, 1, 26, 7)
+	},
+	{
+		/* Family */
+		Altera_StratixV,
+		/* Interface type */
+		passive_serial,
+		/* No limitation as additional data will be ignored */
+		-1,
+		/* Device function table */
+		(void *)&stratixv_fns,
+		/* Base interface address specified in driver */
+		NULL,
+		/* Cookie implementation */
+		/*
+		 * In this 32bit word the following information is coded:
+		 * Bit 31 ... Bit 0
+		 * SPI-Bus | SPI-Dev | Config-Pin | Done-Pin
+		 */
+		FPGA_COOKIE(1, 2, 29, 9)
+	},
+};
+
+/* Add device descriptor to FPGA device table */
+void board_fpga_add(void)
+{
+	int i;
+
+	fpga_init();
+	for (i = 0; i < ARRAY_SIZE(altera_fpga); i++)
+		fpga_add(fpga_altera, &altera_fpga[i]);
+}